Tuesday, December 15, 2015

Panda Bear Hug Gift Card Holder

Panda Bear Hug Gift Card Holder-JMRush
Approximate Card size: 4” x 7.75” 

This card features character arms that open to release a hidden gift card section. This design is compatible with both 8X12 and 12X12 mats. 

1.Cut design pieces. (I used double sided cardstock for the card base) The Panda’s paws (2 half oval shapes) are not shown in these photos.…sorry.
2. Fold the card along score lines.
3. Apply glue the bottom of the side tabs on the card base. Secure by folding upward toward the card base.
4.Apply glue to bottom of the backside of thePanda head piece with the smallest eyes. Center and attach it to the solid head base. Glue the belly rectangular strip to the card base.
5. Apply glue to the backside of the face piece with the largest eye holes and secure to the combined head piece. Using foam adhesive square ,attach the nose to the combined head pieces.
6.Glue the combined head piece to the card base.
7. Glue the hat piece to the back of the card base. Using foam adhesive squares, attach the hat trim and puff ball to the hat.
8.Insert gift card.
9.-10. Glue the hands to the front of the arms. Finish with ribbon and I used enamel dots to enhance the eyes. The hands tuck into the slots on the front:)

No comments:

Post a Comment