Wednesday, December 28, 2022

Valentines BirdHouse Treat Box








 Valentines BirdHouse Treat Box-JMR

Approximate size: W 3 x D 1.75 x H 3.5”

Approximate box size: W 3 x D 1.75 x H 2”


This cute bird house treat box opens from the handles on the top. This design is compatible with both 8X12 and 12X12 mats.

You can purchase the Silhouette design file here: https://www.silhouettedesignstore.com/artists/485222


You can purchase the SVG and Cricut compatible file here:https://www.jamieandjenn.com  Coming Soon:)




1.Cut design pieces. ( I used double sided card stock)

2. Flip the birdhouse box over and fold the bird house base at the score lines.

3. Connect the two wing tabs on the bottom.

4. Apply glue to the bottom of the connected wing tabs and fold in the small bottom tab. Hold until secure.

5. Apply glue to the bottom of the birdhouse box and secure the last large square bottom panel; aligning at the edges.

6. Apply glue to the side tab and connect the side panel.

7. Curve the flowers and leaves as you like.

8. Combine the two large petal groups by glueing the middle circle; Larger on bottom and alternating petals. Repeat for the two smaller petals. Glue the smallest circle to the larger one; centering it.

9. Glue the two petal groups together; alternating petals. Glue the leaves to the bottom of the combined flower. Attach a piece of foam adhesive to the bottom.

Attach the combined circles with a piece of foam adhesive square as shown.

10. Attach the combined flower as shown. Push in the two top handle panels.

11. Apply small pieces of foam adhesive square to the backsides of the two triangular roof top pieces and attach to front and backside of the birdhouse box.

12. Finish with a ribbon and I used an adhesive jewel for the center of the flower:)

 

No comments:

Post a Comment