Labrador Double Sticky Note Holder

Labrador Double Sticky Note Holder-JMR

Approximate size: W 4” X H 3.5” X D 1”

This Sticky Note holder features a pen holder on the side and holds two standard sized stack of sticky notes; one on the inside and the other in the pocket in the back of the design. This design file is compatible with both 8X12 and 12X12 mats. 

You can purchase the Silhouette design file here: https://www.silhouettedesignstore.com/artists/485222

You can purchase the SVG and Cricut compatible file here:https://www.jamieandjenn.com  

1.Cut design pieces. I used double sided card stock.

2. Flip the base over as shown ( pretty side down). Fold at the score lines at the pen holder section. Top and bottom sections fold in and the center section folds out.

3. Flip the base over as shown. Fold the side tabs as shown.

Apply glue to the small tabs on either side and glue downward; creating a pocket. Hold until dry on each side.

4. This is what the backside will look like:)

5. Turning the base over- Insert the back of a sticky note stack inside the slot provided.

6. Insert the second sticky note stack into the backside pocket.

7. Center the square panel on the front of the base. You may need to turn this piece to make sure it has proper spacing all edges. Using foam adhesive squares, attach the lab head piece with eye holes to the solid dog base.

8. Curve the small dog tongue as you like. Using foam adhesive squares, attach the black nose to the muzzle piece and the ears to the coordinating shapes on the combined dog. Glue the tongue by sliding it underneath the open section of the combined dog. 

9.Use a piece of foam adhesive square to attach the nose to the combined muzzle. I glued the top tips of the ears down to the combined dog base and used adhesive jewels to accent the eyes.

10. Insert a pen and finish with a ribbon:)